jestre
|
 posted on 20/12/05 at 04:55 PM |
|
|
DIY Sheet Metal Brake
Has anyone tried to make one?
http://www.majorleagueduning.com/tech/Brake/Brake.htm
-=too much horsepower is just enough=-
|
|
|
|
|
joolsmi16
|
| posted on 20/12/05 at 07:24 PM |
|
|
Sheet bender
Looks straight forward enough especially if you have some heavy guage metal to hand, may be costly otherwise.
And the temptation to make one large enough to bend the top and bottoms of the side panels with always be in the back of your mind.
|
|
|
NigeEss
|
| posted on 20/12/05 at 07:54 PM |
|
|
Not from those plans but same idea.
Hmm... no piccy. Have a look in the archive.
[Edited on 20/12/05 by Nige_S]
|
|
|
02GF74
|
| posted on 21/12/05 at 09:06 AM |
|
|
I've seen/read about something similar made from angle iron and heavy duty door hinges.
|
|
|
