Hadders
|
| posted on 15/3/09 at 06:57 PM |
|
|
Anyone with a lathe in Herts?
Does anyone have a lathe or can recommend a company who could do a small job for me in exchange for a few beer tokens?
I have a block of ali which needs a whole turning in the centre to accept a bearing. Shouldn't take more than 10 minutes.
I'm in St Albans, but i'm happy to travel in Herts / North London.
TIA
|
|
|
|
|
MakeEverything
|
| posted on 15/3/09 at 08:17 PM |
|
|
quote:
Originally posted by Hadders
Does anyone have a lathe or can recommend a company who could do a small job for me in exchange for a few beer tokens?
I have a block of ali which needs a whole turning in the centre to accept a bearing. Shouldn't take more than 10 minutes.
I'm in St Albans, but i'm happy to travel in Herts / North London.
TIA
You need a mill not a lathe??
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
|
BenB
|
| posted on 15/3/09 at 10:23 PM |
|
|
If it's a circular hole a lathe would be favorite 
I'm planning on using someone off Ebay for my machinework on the basis they're seriously cheap!!
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=200313469391
|
|
|
