carlknight1982
|
| posted on 21/11/09 at 02:56 PM |
|
|
recommend me a plasma cutter
im looking to invest in a plasma cutter, any recommendations or sets for sale?
Logic will get you from a A to B
Imagination will take you everywhere.
|
|
|
|
|
JoelP
|
| posted on 21/11/09 at 02:58 PM |
|
|
i bought a clarke one, works fine. Stopped for a few years til i realised it just needed a new tip! Works fine again. Was something like 450 i think.
|
|
|
RAYLEE29
|
| posted on 21/11/09 at 07:06 PM |
|
|
hey Carl did you get the pinto running?
Ray
[Edited on 21/11/09 by RAYLEE29]
|
|
|
mark chandler
|
| posted on 21/11/09 at 08:57 PM |
|
|
look at the price of the consumables, I have a cerboro one, big mistake as the tips cost £££
Cannot convert to a cheap head as its not HF start, right pain in the rear.
Regards Mark
|
|
|
clanger
|
| posted on 22/11/09 at 09:26 AM |
|
|
I got me one of the Chinese ones. A 40amp Berlan. Its an obvious Chinese one even though it came from Germany off E-blag, but I've had no
problems with it at all. Supposed to cut 10mm, but in reality 6mm tops. I use it for thin plate up to about 3mm and rusty Mini panels and its great,
just flies though the thin stuff. Consumables cheap also.
Here she is:
|
|
|
