Hi all

Going to get fitted a roll cage and side impact bars next week and looking for ideas and inspiration,

I was hoping to get some close ups of how you or raw have welded in the front hoop to behind the dash,

Like photo link attached,

Or if you have it a chassis pic with the full bare look,

Appreciate any pics

Link

http://www.flickr.com/photos/querth/3362760593/

[Edited on 27/10/12 by INDY BIRD]

Like this where the dash bar meets chassis how this welds in?

Link
http://classifieds.pistonheads.com/classifieds/advertgallery/830394/4


Thanks all

Most of the ones I have seen the rollcage goes outside the dash down the side of the car. Extra welded plate on the inside the bolted through the side. These are the first ones I have seen that go through the dash.

Not a striker but the same really



Always feel safer with bars all round.

I assume your talking about a classic striker set up with the triangular skuttle. Where as the fulcrum and mine are based on the optional 'modern' style:




Heres some others ive seen:


Description


RawStrikerNorthDemoChassis





http://www.rsfabrications.com/2009/07/09/striker-raw-with-toyota-4ag-motor-gets-silencer-for-track-days/

[Edited on 28-10-12 by loggyboy]

quote:

---

Most of the ones I have seen the rollcage goes outside the dash down the side of the car. Extra welded plate on the inside the bolted through the side

---