Can any one tell me how to cut holes in sketchup?

Thanks in advance

Cheers

Chris

used a hole saw, made a mess of the monitor.

Nearly as bad as when I was using the tippex in "Word"

Cheers

Chris

Like this?

Draw a circle on the surface you want a hole in and then pull it downwards so that it removes the material. Assuming you want a circular hole that is...

Edit: Just tried it and it works

[Edited on 21/1/06 by greggors84]

Now even bigger and bader!

Always trying to go one better!

What program you use to turn that into a gif? Im guessing you didnt do loads of screen dumps!

Bulent's Screen Recorder to capture what I did into an AVI file which was promptly turned into a gif with the help of 123 AVI to GIF Converter

Thanks mate!

When you select the face inside the circle how do you remove it?

I'm so very stupid.

Thanks

Chris