Hi
am thinking of using mikuni 40mm slabsides from a GSXR on a 1.6 xflow, the gsxr inlet rubbers are bolted directly onto the gsxr engine, can i get away
with copying this ie bolting the rubbers onto a plate which is then bolted to the xflow head without using lead tubes or will i have problems with the
carbs being to close heat etc?
Can't see why not - they are that close on the bike.
Stu
does anyone know of anyone putting bike carbs on a 1300 xflow if so which ones?
Hmm 1st problem the dizzy gets in the way !! How do i get round this ??
Remove it and fit Megajolt! Alternatively, get a dizzy cap that has side exits.
Thanks - megajolt ordered from paulf now just got to find edis etc.