Trying to fit an Acumen to a ST LOCOBLADE.
Using the Tacho feed, the speedo sensor from the fireblade engine. Car has no speedo so on the speedo sensor I am using a pos feed to one wire, one
to earth and one as the sensor output
It recognises neutral but doesn't want to learn - any thoughts?
(company said fit a 10K resistor in pos feed)
They are a bitch to get to work m8 when it goes well its fine but not many get them to work reliably with blade engines...
Steve
Read this LINK
HIH
[Edited on 22-8-08 by Hellfire]
Oh dear good luck! I gave up with mine on an old Blade engine even after fitting the sensor kit supplied free from Acumen.......