finally finished the painting and put her back together all i need now are my plates and im ready to get on the open road
chris
[Edited on 17/5/09 by chris_smith]
what happened to the OSR wheel arch?
put some mud flaps on the front........trust me it will be the best thing you do.....other wise your baby blue will be stone chip black.
Had mine out for a bit and its filthy....but then again its done 1500 miles in the last few weeks.
Its first legal run was 750 miles
HEEEEYYYYYYY!
Great stuff!
You must be thrilled, it's turned out really nice mate!
Did you use that rear panel in the end? If so it looks good with the paint job.
Once your on the road drop me a u2u if you don't mind an excited passenger? I'd love a bit of encouragement prior to getting mine on the
road.
Cheers
Andrew
Very smart.
Blue seems to have richened up from your previous post.
quote:
what happened to the OSR wheel arch?
quote:
Did you use that rear panel in the end? If so it looks good with the paint job. Once your on the road drop me a u2u if you don't mind an excited passenger? I'd love a bit of encouragement prior to getting mine on the road.
quote:
Blue seems to have richened up from your previous post.
quote:
put some mud flaps on the front........trust me it will be the best thing you do.....other wise your baby blue will be stone chip black.
in your last photo the OSR wheel arch is lower than the boot tub floor,is it supposed to be lower than the boot floor?
[Edited on 17/5/09 by omega0684]
it is the same on both sides, all the parts have been bought/given from here there and everywhere and none of the parts are a match so iv done the
best i can with the parts to hand, to get the arches to "look right" then thats the position i found looked better, i think it looks good
and am happy with the result considering the mismatch of pieces/parts
cheers
chris
that looks spot on!!
loving the blue
quote:
Originally posted by chris_smith
it is the same on both sides, all the parts have been bought/given from here there and everywhere and none of the parts are a match so iv done the best i can with the parts to hand, to get the arches to "look right" then thats the position i found looked better, i think it looks good and am happy with the result considering the mismatch of pieces/parts
cheers
chris