hi im after a set of cycle wing brackets has any one used the rally design ones or these

http://www.ekmpowershop9.com/ekmps/shops/gtstuning/wing-stays---front-cycle-wings---sierra-uprights-108-p.asp
if you have what did you think and do you have photos

cheers doddy

[Edited on 29/4/10 by doddy]

never used either, but do your research

you'll find a huge difference between RD customer servive and GTS customer service. have a search on here

[Edited on 29/4/10 by blakep82]

GTS supply rally design with alot of parts, this may be one of them.

If GTS is close to you then go down with the money and get them.

yes i could go get them from gts as there about 1.5 hrs away i dont mind the drive have people had problems with postage then

quote:

---

Originally posted by doddy
have people had problems with postage then

---

As far as i'm aware GTS no longer supply RD, RD now have stuff made in larger quanties the usual way....

I had a pair for a set of cortina uprights and they no where near fit.

U2U sent!

Big Wasa's correct, Cortina one's take a fair bit of modding to fit correctly, I also didn't trust the flat strip on both arms, so welded a piece of round to the rear stay. You can just make them out in this pic.



stripped

ATB Dan.

Hi, have you ordered a set of these? I am after a set also, will you let me know what they are like?

quote:

---

Originally posted by Wumps
Hi, have you ordered a set of these? I am after a set also, will you let me know what they are like?

---

i had a set of the cortina ones and they were miles out from lining upto the mounting holes in the hub

sent mine back for a refund as it would be very hard to cure the fault and for all that work you may as well make a pair.

i ended up using a set from procomp which i am very happy with