I have had a quote to powdercoat my wheels for £35 each. Is this the going rate?
Yep...
i paid 150 for my tintop so i would say about right
dave
There's a place in Idle, Bradford that does (or used to do less than a year ago) strip and powdercoating for a quid per inch (diameter). Fancier
finishes (chrome, 2 colour etc.) cost more of course.
I've heard nothing but good stuff about them, I found out about them just as I'd finished sanding/stripping/priming/painting and clear
coating a set of 4 wheels, with £40-50 worth of rattle cans 
They don't fill any dents/scratches, they bake the wheels in an oven to strip the old paint then powdercoat them.
CAS Coatings
Old Mill, Victoria Road
Bradford, West Yorkshire BD2 2BH
01274 634 493
Just make sure that they clean the wheels properly. I paid £45 per wheel at a place just outside Carlisle and the guy chucks them up on the lathe and skims the rim if it is marked (but not too much)!. Does a nice job.
quote:
Originally posted by UncleFista
There's a place in Idle, Bradford that does