ok so ive started fitting my grp rear end, to discover that i have a rather nasty ragged gap of about 4mm at its widest between the rear and the sides, i need some trim to go in here, any recomendations?

ive been thinking about a bead of black silicon to cover it as my bodywork is anthracite in color so i wouldnt get a match.

[Edited on 30/5/11 by carlknight1982]

It would be better to fill it with some rubber sheet?

Would tadpole trim work?

Who supplied the bodywork?

saturn. its my mis measurement thats faffed it up, i cut 10mm short i should have had about 6mm of grp in excess to clean the cut but alas nope.

Ah ok, i was wondering how it happened.... Saturns is usually very good.

saturn gear is spot on my dodgey cuttting

cany tou cover with vinyl of the same colour

its where the side panel meets the rear tub, and part of it is covered by the wheel arch im not sure i would get a vinyl the same color look at my pics www.carlsroadster.blogspot.com