I'm looking for some advice - any dvice on how to trim the shoulder bars on my haynes roadster. As per the picture below, on the left you can see the curved bar (3mm thick strip) coming down. On the outside it forms a right angle corner with the aluminium sheeting, on the inside it is just a piece of strip so would need edge trim or similar.

Any tips much appreciated.

Cheers

Dave


Description

Hockey stick alluminium moulding is the norm

i did it like this on my roadster. used rubber u trim spread out then glued on for the corner then put rounded trim over the top

this stuff for the top

http://www.cbsonline.co.uk/product/17.5_x_3.5mm_Satin_Black_Trim_Flat_Self_Adhesive_Trim_TRMB2

and this stuff for the sides.

http://www.cbsonline.co.uk/product/10_x_5mm_Rubber_U_Channel_For_2mm_Panels_TRMU2

Thanks Ash

That's great - will get some on order.

Cheers

Dave