I have built the 442E chassis to enable me to shoehorn in an M52 engine from a BMW but I'm struggling to source a nose cone.

Are there any manufacturers that supply a nose to fit a chassis this wide?

How wide do you need it? Haynes roadster bodywork should fit over the engine but depends on the chassis dimension.

I have all the bodywork dimensions if you need them

I have a nosecone second on eBay if you want one to chop about to make it fit

I don't think height is an issue but the chassis at its widest point at the front is 750mm.

Do you have a link to the eBay item, I've searched but cannot find it?

edit. Found it.

[Edited on 25/5/16 by james-w]

Have a look if it's any good usually me and we can do a deal
Haynes roadster nosecone second

[Edited on 25/5/16 by Vmax1974]

https://drive.google.com/open?id=0B7TIJWZFnR1ueHEyVHIzOUFPSzA

https://drive.google.com/open?id=0B7TIJWZFnR1uODlmVGQyYzhHRmM

https://drive.google.com/open?id=0B7TIJWZFnR1ubm96OFN2NndQM0U

That's the equinox Haynes roaster nose one which I'm guessing is pretty much same measurements as vmax's one.

Hopefully you can get the links to work ok

quote:

---

Originally posted by Ben_Copeland
https://drive.google.com/open?id=0B7TIJWZFnR1ueHEyVHIzOUFPSzA

https://drive.google.com/open?id=0B7TIJWZFnR1uODlmVGQyYzhHRmM

https://drive.google.com/open?id=0B7TIJWZFnR1ubm96OFN2NndQM0U

That's the equinox Haynes roaster nose one which I'm guessing is pretty much same measurements as vmax's one.

Hopefully you can get the links to work ok

---