Well can you?
Rescued attachment Buck.jpg

rear wheel arch mould?

A really big minging green cheese wheel?

maybe a little further forward than a rear arch? bracketing will be a bugger though!

looks promising.
tom

Or a loo seat in the making for someone with a REALLY wide ass?

A sort of rabbit type thing?

Spare wheel cover?

quote:

---

Originally posted by DIY Si
Or a loo seat in the making for someone with a REALLY wide ass?

---

CHEESE gromit

Wheel for a blind hamster?

Any more ???

Anyway, it will be a 180 degrees front cycle wing buck with a very close fit on 13" wheels.

Nobody makes cycle wings to suit a 13" so I though I'd have a crack myself.

Watch this space as they say - will take a few weeks though!

Pat...

Cover for a flat tyre ?

Would only make one comment Pat, don't make the same mistake that I did, and make the side skirts too deep. After fitting my guards I couldn't take the f*****g wheels of, Doh! ATB Ray.

i couldnt get my wheels of easily so i welded a nut in the supports and thred locked bolts in so i could remove wing before wheel.
also enables you get wing closer to the wheel.

Cheers.

They were close on my Avon, but just right.

Approx 10mm air between arch and tyre.

Pat...

Are you going to put vents in the top, or a little wing ala Caterham and the CSR? to help reduce pressure under them?

Or is the plan to get them so close you don't need them?

Mike

Good for you Pat..at last a cover for those daft 2 quid coins.
Sent you u2u by the way.

Mark

It's a round of Edam with a puncture...