anyoneknow if the velocity bodywork will fit a book(well ST) chassis??.

Sure does Ray, its what i am doing and all the panels fit really quite well!

nice on cheers.

do you already have your bodywork then??,

would you be able to take a few measurements for me??.


BTW loom is done, will all be in the post this weekend!

Ray

yea its all kinda on.. i am just about to leave my workshop so if u are quick i can get measurements!

Iv got velocity body on my locost. Fits a treat. The only problem i had was with the scuttle. Its very slightly to wide so it overhung the chassis by about 2 mm either side so i had to move it back a bit which created a bigger gap where the bonnet sits.

Its the same for there locost scuttle aswell. I know other people have had this problem. Definatley rusty nuts has.

may be different with the new owners.




U2U me if u want to know anything.

[Edited on 11/8/06 by Danozeman]

[Edited on 11/8/06 by Danozeman]

dam pictures. If u look in my archive in the chassis pics folder. The a piccie in there. near the bottom P1010058.JPG

[Edited on 11/8/06 by Danozeman]