Hi All

Anyone know where I can get hold of aluminium (trailer/motorcycle?) wheel arches as I intend to panel whole car (including arches, scuttle and nosecone) in ally.

I have access to welder which (apparantly) is good for welding aluminium, so thought that if I could cut the compound curves from the wheel arches and weld them to bent sheet, it would save a lot of beating!!

As for the nosecone, the intention is to fabricate various parts and weld together.

Has anyone already tried this, and did they have much success?

Thanks

Simon

Have at look at this site:-http://www.gibbs111.fsnet.co.uk/homepage.htm

Yes that is a good website!!!!

My nose cone is ali, but my wings are GRP, details on the site

Cheers

Chris

I thought you would like the plug, and yes it is a good site.

Thanks mate!

Chris,

Great looking car and very informative site.

Seems all my points have been answered!

Thanks

Simon