Are there any pics or manufacturers of them?
Dale

I know MNR do some that can be cut down to 180 but I am not sure if this is waht you are looking for.

Steve

I am just playing with different ideas for the front fenders. 180 or possible 270 degree fenders with a more vintage ridge down the center is an option. I understand that anything over 180 degrees would be a two part mold or a two part fender. I am trying to come up with something that looks like it could have come out of the 1930s or so that will match into my rear fenders. I have done sidepods with a clam shell type but still not sure its what I want.
Thanks for the MNR idea.
Dale

[Edited on 3/2/08 by Dale]

anything much over 180 will need careful design to ensure you can get the wheel in!

Yes I know it could have no tire overlap or it would never fit on or off. Also harder to mold.
Thanks
Dale