alfas
|
| posted on 22/1/16 at 05:26 PM |
|
|
certification-mark stamp for Polycarbonate / Macrolon
does anybody know where to get a stamp to mark polycarbonate with a certfication-mark...or a link to a manual how you can make your own stamp?
its a kind of waved symbol.
our tüv does not allow wind deflectors without any marking / approval-sign..
no, i do not wan to remove them for the test, as there will be taken pictures which will be kept as reference for the next test or if the
police-officer stops you and complains about the missing mark.
[Edited on 22/1/16 by alfas]
|
|
|
|
|
coyoteboy
|
| posted on 22/1/16 at 09:11 PM |
|
|
Surely fraudulently marking them is as bad as being caught without? Less likely I guess.
You could make a mask via 3D printing or laser cutting and then grit-blast it on.
|
|
|
alfas
|
| posted on 23/1/16 at 10:30 AM |
|
|
i do not know anybody with a 3D printer. how is it marked? by engraving or by heating a stamp or both ways?
[Edited on 23/1/16 by alfas]
|
|
|
coyoteboy
|
| posted on 23/1/16 at 11:33 AM |
|
|
You can use shapeways.com or protolabs.Co.UK. a mask should be pretty cheap. As for how they mark it officially - no idea. I'm guessing laser
etch.
|
|
|
