the_big_1
|
| posted on 20/6/20 at 08:25 PM |
|
|
Rear round trim?
hi all,
I was looking at using the aluminum hockey stick type trim form my side trim along the area your arms would be, but can you mould it to fit the round
part level with your shoulders or have you used something else???
|
|
|
|
|
bigrich
|
| posted on 21/6/20 at 07:52 AM |
|
|
If you cut a small relief notch in the hockey stick on its curved edge you can the bend it at the point it goes up towards your shoulder and form it
all in one piece
.JPG)
A pint for the gent and a white wine/fruit based drink for the lady. Those are the rules
|
|
|
40inches
|
| posted on 21/6/20 at 09:08 AM |
|
|
I made a former out of MDF and clamped it in the vice, it bent relatively easy.
If you haven't panelled the inside yet you can bend it on the car using G clamps 
 
Description
|
|
|
the_big_1
|
| posted on 21/6/20 at 09:51 AM |
|
|
Did you have to use reliefes?
How do you do them without them looking horrible lol
|
|
|
