John Stones
|
| posted on 20/2/22 at 05:24 PM |
|
|
rear bodywork
Hello to anyone watching.
Has anyone thought about making a fibreglass
one piece rear panel and wings. I have and made
a success of it. The moulding tucks under the rear
low chassis rail and held in place with 3 m6 screws.
The front edge of the wings are held in place, one at
lower edge into the side panel, the other a little higher
into the triangular plate in the chassis, the holes for the
screws are m6 rivnuts. Just thought I would share.
|
|
|
|
|
bi22le
|
| posted on 20/2/22 at 05:31 PM |
|
|
Sounds similar to the JPSC striker 1 piece that I have.
It does not quite tuck all the way forward to the lower rail, but it's not far off. Arches and tube are single piece.
Track days ARE the best thing since sliced bread, until I get a supercharger that is!
Please read my ring story:
http://www.locostbuilders.co.uk/forum/13/viewthread.php?tid=139152&page=1
Me doing a sub 56sec lap around Brands Indy. I need a geo set up! http://www.youtube.com/watch?v=EHksfvIGB3I
|
|
|
