Andy D
|
posted on 25/6/08 at 09:14 PM |
|
|
Perforated tube
My sons car exhaust silencer (repackable)has a broken inner perforated tube, Its 30" long, and fits over 2.5" stub pipes inside the box.
Is there anywhere in the North east where I could get a replacement? Or any mail order type scources?
Should think I'd get one from Simpsons or Wunoff if all else fails..
|
|
|
Volvorsport
|
posted on 25/6/08 at 09:23 PM |
|
|
jetex or something like that .
custom chrome etc
www.dbsmotorsport.co.uk
getting dirty under a bus
|
|
iank
|
posted on 25/6/08 at 09:23 PM |
|
|
Merlin Motorsports are one.
http://www.merlinmotorsport.co.uk/EXHAUSTS-Merlin-Silencers-Silencer-Components/c223_228_229/index.html
--
Never argue with an idiot. They drag you down to their level, then beat you with experience.
Anonymous
|
|
smart51
|
posted on 25/6/08 at 09:33 PM |
|
|
milner off road sell it by mail order here
|
|
miikae
|
posted on 26/6/08 at 09:04 AM |
|
|
solid-fab on ebay do perferated stainless tube 2.5" od and 3" od , not cheap though. item no 320257820072 for 2.5"
Mike
If it can be done it i will be done .
|
|
Andy D
|
posted on 26/6/08 at 06:32 PM |
|
|
Hmm, most of the pipes available are 2.5" o/d, they wouldn't slip over a 2.5" o/d pipe. Cant find a local supplier, so its
looking like a job for an exhaust specialist.
Thanks for the replies, open to any other suggetions.
|
|
CairB
|
posted on 26/6/08 at 07:46 PM |
|
|
quote: Originally posted by Andy D
Hmm, most of the pipes available are 2.5" o/d, they wouldn't slip over a 2.5" o/d pipe. Cant find a local supplier, so its
looking like a job for an exhaust specialist.
Thanks for the replies, open to any other suggetions.
I used the Milner 2.5" perf tube when I made a silencer recently. I made end joint sleeves by slitting some 2.5" tube and opening it up to
fit over the tube.
As its perforated the gap didn't matter. Could you do something similar?
[Edited on 26/6/08 by CairB]
|
|
Andy D
|
posted on 26/6/08 at 09:11 PM |
|
|
quote: Originally posted by CairB
quote: Originally posted by Andy D
Hmm, most of the pipes available are 2.5" o/d, they wouldn't slip over a 2.5" o/d pipe. Cant find a local supplier, so its
looking like a job for an exhaust specialist.
Thanks for the replies, open to any other suggetions.
I used the Milner 2.5" perf tube when I made a silencer recently. I made end joint sleeves by slitting some 2.5" tube and opening it up to
fit over the tube.
As its perforated the gap didn't matter. Could you do something similar?
[Edited on 26/6/08 by CairB]
Yes, allready thought of doing something like that, if all else fails. Perhaps a jubilee clip or two to keep it all tight.
|
|