Just got my new rear wheel bearings from burton bt910 kits came with one seal each kit
checked with them and that's correct got my old ones ( what was left off them ) out and the new races in but the question is
since the old bearings had seals front and rear witch side do I put this seal on front or rear

or wheel side / prop shaft side

For sierra / Granada rear hubs ?

They must have 2 new seals each side - just like the pic on burtons web site:

http://www.burtonpower.com/wheel-brg-kit-r-sierra-cosworth-xr4x4-abs-granada-mk3-brt910.html


Who ever told you they only need one is telling you lies...

This is from the cossie manual, same type of hubs just a size bigger

You should definitely have two seals, one each side of the bearing.

As mentioned loads of times, make sure you torque the hub nuts correctly....214lbft rings a bell but don't quote me.

cheers guys sorted it with burton they are getting me new sent out