i cant get the hoze to seal with a jubilee clip at the petrol tank inlet.
hoze is the type with a coiled wire set within the rubber,has anyone else had this problem with mnr supplied hoze.

have you tried using a fuel hose clip and not a jubalee clip

[Edited on 8/4/09 by omega0684]

what he said , petrol hose should have proper
hose clamp - not jubilee

GeorgeM

If it is the fuel filler hose you are on about which from your description it sounds like I doubt you will get a fuel pipe clip that big. I bought my jubilee's locally and got them just bigger than the hose diameter (50mm) so I didn't have to tighten them much as they do tend to distort and not stay round, perhaps this is your problem. The filler hose should be a tight fit onto the tank inlet and the filler cap aswell.

Mine was tight and still leaked. Make sure if possible you get it between the spirals. Then go a bit tighter till leak stops.
Adam