Afternoon, happy xmas and all that
I have just come to fit the bonnet scoop to my MNr that I got off MNR a few months ago and Im a bit puzzled as to how to do it. My first though was
glueing front and back would hold it but on closer inspection when i put the scoop on the bonnet only the 4 corners touch the actual bonnet due to the
curve of the bonnet and the scoop.
An suggestions/methods you have used for fitting yours?
Cheers
Paul
If it is anything like the carbon mods one, I sanded the corners so it was flush with the bonnet and sikaflexed 4 "L" shape brackets on and
bolted it to the bonnet through these.
You could always used "U" trim where it meets the bonnet if you don't want to sand, or use even more sikiflex instead of bolting it
on.
HTH
SHaun
am sure the mnr guys use sikaflex.it really does get a good hold.