Hi all

Does anyone know where I can get a replacement rear Camber adjuster, i can't find the type MNR use any where.
I know I can get them from MNR but at nearly £50.00 each they seem a bit expensive, wondered if I could get them cheaper anywhere else.

Cheers

Are you talking about the Aluminium adjuster? I can't believe MNR want £50 for one of those, a new wishbone isn't that expensive!!

I have seen them on eBay for less than that for a pair in steel, and I believe that Flack Monkey makes them.
http://www.locostbuilders.co.uk/viewthread.php?tid=156335

[Edited on 2-10-12 by 40inches]

Hi

Yes I am talking about the aluminium adjusters, Chris at MNR quoted £44.00 each plus £5.00 postage.
I have struggled to find any the same online, only ones for the front but hese are too short !!
I'll have a look again on eBay, steel would be better, bit worried about the same thing happening again and stripping some of he treads and ending up with a horizontal wheel !
I'll u2u flack monkey too,
Thanks for the advice
Cheers

[Edited on 2/10/12 by Markyb13]

Are mnr rear ones diffrerent to the usual front ones? L0cost/haynes style front ones that were readily available in alloy and steel versions, but do they suit the MNR rear?

if you send/bring me the other one or a very accurate drawing i can copy it for you but i will only make it in steel as ali is crap for this sort of thing.

[Edited on 2/10/2012 by ashg]

Hi
Thanks for your reply, i will endever to get the other one off and send you the details or the part, if you could fabricate it that would be great.
Cheers
Mark

Hi all

Thanks to those that replied, I have managed to track down the person hat was selling hem earlier this year on eBay, now ordered and sorted
Cheers