DOES ANYONE HAVE A BETTER PICTURE<

Because if i fit my radiator as below where i am holding it!!, i have a weld below each bracket? is this in the right spot and how have other people fixed theres??



[Edited on 26/3/06 by Krismc]

I had a similar problem, I ended up putting the rad at a bigger angle than in the manual, in order to get hose clearance.
I think it should be OK, but not tested yet.

Steve.

There are some Pics in my archive.

Ignore the fan ties, they need to be changed.

cheers ill take a look!?!


... had a look, did you just rivot the bracket to the chassis? and im sure that angle should be fine!

[Edited on 26/3/06 by Krismc]

i used rivnuts to fix the upper brackets and made little plates to rivet the lower mounts.
looks like you have a tube upper chassis rail which might make rivnuts pretty hard to use.

i had to angle the lower mounts away from the chassis enough to get a 90 degree silicone hose bend in there.

cheers i better get a bit of pipe to see how it fits first!!