Board logo

Inboard suspension fitting
vinny1275 - 2/7/07 at 08:12 AM

Morning all,

Tried trial-fitting the front suspension at the weekend (I wanted to test it out before I get anywhere near bodywork)... I fitted the pivot for the shock / pushrod, but the spacers I have are too big to fit the eye into the pivot mounting. For the other RT builders on here, did you have more than one size spacer? Mine are all about the same size (about 7.5mm long), but it looks like they should be more like 6.

I would call Marc, but he's off on his honeymoon for a fortnight......

Anyone any ideas?

Thanks,


Vince


amalyos - 2/7/07 at 10:01 AM

I did file some of my spacers down. There was only 1 size.

Steve


zxrlocost - 2/7/07 at 10:18 AM

hi vince there is a pic on your site where a brake pipe goes up in there air round down then into a P clip

I dont know if this is finished or not but I would shorten it

thanks chris


Agriv8 - 2/7/07 at 12:39 PM

vinney,

Back from arran post up a photo ( as I can visiualise which bit you are on about )if you can.I hope I would be able to advise in marcs absence.

Regards

Agriv8