I'm going to take the plunge and cut the holes in the body tub this afternoon.
Cardboard templates done, but what diameter holes have others used?
There are two holes pre-drilled in the front of the tub, one each side. These align with the upper front wishbone fixing, although offset from centre. I am assuming this marks the required centre position for the hole to compensate for the wishbone angle as it comes through the body. Any body confirm this?

hi graeme

i use a 76mm holesaw ( only because thats the largest i have ) front pilots holes are the ones i use

best regards
marc

the one i use for the pushrods is a 38mm

cheers
marc

Thanks Marc.
By the way did you find my other exhaust bits?

Cheers
Graeme