I expect most of you will already know this, but for those that don't-
If you are adjusting the intonation, it's always best to start with a new set of strings, and while the strings are off, wind the bridge pieces
back towards the tailpiece. There's 2 reasons for that, first, it's always easier to wind the bridge pieces forwards when the strings are
back on that it is to wind them back, and second is that when the strings are tightened, they can get a slight kink where they rest on the bridge, and
that can affect the intonation. If the bridge is already back as far as it will go, then that kink will be the otherside of the bridgepiece when it
moves torwards the neck, and so won't matter.
Apologies to the guys that already knew that, just one of those little tips that makes life easier.
Don't throw away your old analogue meter, if you've got one
When getting ready to install a new pickup to be used in conjunction with another pickup from a different maker, you can check the phase of each
pickup by connecting the meter across the output and putting it on a sensitive dc volts scale.
Then, put a piece on metal on the pickup, and sharply pull it off. Looks to see which way the needle moves. Then check the other pickup and if the
needle moves in the same direction, you'll know it's in phase. If not you will need to reverse the wires on one of them.
And don't forget to turn up to 11 when finished.
quote:
Originally posted by Liam
And don't forget to turn up to 11 when finished.
No you need 11 or it doesn't work
If you're not sure, try this simple tes-t hold the 3rd string down at the first fret, and the top fret. If you can see a slight gap between it
and the frets halfway along then that's right. The gap should be big enough to see, but no more.
If you're not sure there is a gap, try picking the string between the two fretted positions. It should sound cleanly, but make sure it's not
resting on one of the frets in between by moving the fretting fingers one fret and making sure the note changes.
If you have to back the trussrod off, give it a little while to settle before you check again. If you have to tighten it, try to bend the neck forward
a bit to take the strain off the trussrod nut, sometimes they stick and the trussrod can break (fairly common on Fenders at one time)
have you won a Gibson SG on ebay?
quote:
Originally posted by 02GF74
have you won a Gibson SG on ebay?
quote:
Originally posted by mr henderson
quote:
Originally posted by 02GF74
have you won a Gibson SG on ebay?
?
quote:
Originally posted by 02GF74
quote:
Originally posted by mr henderson
quote:
Originally posted by 02GF74
have you won a Gibson SG on ebay?
?
I assumed that you have come into possession of a guitar hence posting tuning tips.
I need a hand with a neck replacement ........its a les paul copy that the young one dropped after three days of ownership knocking the top off
ive got a replacement neck but need to make a jig for the router to clean the socket out square. Haven't got round to it but its all complete
quote:
Originally posted by mangogrooveworkshop
I need a hand with a neck replacement ........its a les paul copy that the young one dropped after three days of ownership knocking the top off
ive got a replacement neck but need to make a jig for the router to clean the socket out square. Haven't got round to it but its all complete
quote:
Originally posted by mr henderson
I spent a few years as a guitar repairer/technician I thought I'd post up a few tips. But if it's not going down too well, perhaps I should delete the thread?
I thought I would get more feedback (even if only negative ) form this.
Would anyone like to know about a quick, easy and accurate way to do a fret dress?
yes please,
& i like your phrase of wanting more "feedback"