Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Scuttle / Full roll cage
spdpug98

posted on 23/2/09 at 10:17 AM Reply With Quote
Scuttle / Full roll cage

I did loose fit of my scuttle over the weekend as I had started cutting the holes for my switches.

I know that the back corner/edge of the scuttle should line up with the crease line in the bodywork, but as I have a full roll cage this stops the scuttle from going back far enough.

Has anyone else had this problem and do I need to smooth/cut a section out of the scuttle to make it go back

Cheers





My Blog: http://spdpug98.wordpress.com/

View User's Profile Visit User's Homepage View All Posts By User U2U Member
Mr Whippy

posted on 23/2/09 at 10:29 AM Reply With Quote
might be handy though if it fits through the scuttle as it would make a great windscreen frame and somewhere to mount the mirrors





Fame is when your old car is plastered all over the internet

View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
spdpug98

posted on 23/2/09 at 07:03 PM Reply With Quote
It's not that far into the scuttle it is only about 25mm, but it's still 25mm out









My Blog: http://spdpug98.wordpress.com/

View User's Profile Visit User's Homepage View All Posts By User U2U Member
Gergely

posted on 24/2/09 at 09:14 AM Reply With Quote
We also have the full cage and don't have an issue. I would advise you to put everything in place and ensure that the nosecone meets the side panels at the front nicely, then install the bonnet with the scuttle and you should be able to see if you really need to modify anything. Don't drill or modify anything before you put them in place and are happy with the fit.
We have about a cardboard thickness of a gap between the cage and the scuttle panel and this way everything lines up nicely. We did have to trim the nosecone a little to ensure that it lines up with the side panels, but you will be able to see that.
I hope it helps...
Gergely





Our build pictures

View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
spdpug98

posted on 7/3/09 at 05:06 PM Reply With Quote
Scuttle / Full roll cage

Well spent this morning cutting the nose cone so that we could mount the bodywork complete.

The problem is not as bad as I originally thought, but the bonnet will not fit it is about 8-10mm too long. It wouldn't be a problem if I could move the scuttle back but it is fully against the roll cage

Anyone have any ideas apart from cutting the scuttle









My Blog: http://spdpug98.wordpress.com/

View User's Profile Visit User's Homepage View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.