INDY BIRD
|
posted on 10/11/10 at 01:02 PM |
|
|
mnr vortx boot cover
Hi all
any one know of a manufacturer who makes boot covers for the mnr vortx,
it has a roll bar with rear stays also,
rather be vinyl, than me making one from grp,
cheers
|
|
|
daniel mason
|
posted on 10/11/10 at 01:10 PM |
|
|
mnr sell them? although in carbon effect. easy install with rivnuts
[Edited on 10/11/10 by daniel mason]
|
|
INDY BIRD
|
posted on 10/11/10 at 01:26 PM |
|
|
hi thanks for that
couldnt see them on there web site,
would prefer vinyl though i could call them any ideas on price
if not will give them a shout
cheers
|
|
BigLee
|
posted on 10/11/10 at 04:19 PM |
|
|
Just about to cut mine. They only supply a big rectangle of carbon effect plastic though. All the holes are cut yourself to fit your exact roll cage.
Because my roll cage is slightly taller, the spacings are different, but I would imagine they are all 'slightly' different. If your after
vinyl, why not cut a thin ply-wood frame to support it?
|
|
INDY BIRD
|
posted on 10/11/10 at 05:00 PM |
|
|
ok thanks can get that sheet anyware,
was looking to save time but may have to do it myself then?
wanted more of a boot cover i can take of and on with press studs easy access etc,
cheers
|
|
gavin174
|
posted on 10/11/10 at 09:00 PM |
|
|
This is who I used..
http://www.hoodsgaloreuk.co.uk/
really pleased with the result and a good price too.
http://www.essexkitcarclub.com
|
|
Krismc
|
posted on 25/2/11 at 05:01 PM |
|
|
soft bits 4 sevens i think its called on ebay, send you a paper template you mess around with it and send it back and they make it for you, and send
all the poppers to make it fit etc.
Built, Ivaed, Drove and now Sold - 2011 MNR VORTX RT+ 2000cc Zetec on R1 Throttle boddies.
|
|