GraemeC
|
posted on 25/8/08 at 11:10 AM |
|
|
Body Tub Hole Cut Outs
I'm going to take the plunge and cut the holes in the body tub this afternoon.
Cardboard templates done, but what diameter holes have others used?
There are two holes pre-drilled in the front of the tub, one each side. These align with the upper front wishbone fixing, although offset from centre.
I am assuming this marks the required centre position for the hole to compensate for the wishbone angle as it comes through the body. Any body confirm
this?
|
|
|
marc n
|
posted on 25/8/08 at 03:40 PM |
|
|
hi graeme
i use a 76mm holesaw ( only because thats the largest i have ) front pilots holes are the ones i use
best regards
marc
please email rather than u2u
direct workshop email ( manned 8am till 6pm )
www.mnrltd.co.uk enquireys to :-
chrismnrltd@btinternet.com
|
NOTE:This user is registered as a LocostBuilders trader and may offer commercial services to other users
|
marc n
|
posted on 25/8/08 at 03:41 PM |
|
|
the one i use for the pushrods is a 38mm
cheers
marc
please email rather than u2u
direct workshop email ( manned 8am till 6pm )
www.mnrltd.co.uk enquireys to :-
chrismnrltd@btinternet.com
|
NOTE:This user is registered as a LocostBuilders trader and may offer commercial services to other users
|
GraemeC
|
posted on 25/8/08 at 04:44 PM |
|
|
Thanks Marc.
By the way did you find my other exhaust bits?
Cheers
Graeme
|
|