Sprytny
|
posted on 18/4/10 at 05:37 PM |
|
|
Rear suspension struts cannot be removed!
Hi everyone!
I am trying to remove some rear suspension struts from a Toyota Camry, but there is a bracket which when I try to unbolt, the bolt turns but
doesn't come out at all from either side. Is there something I am doing wrong here?
I will try and post pictures, but thought someone might be familiar with this problem.
Thanks
Greg
|
|
|
tomprescott
|
posted on 18/4/10 at 05:44 PM |
|
|
Is the entire assembly moving? If so, get a rattle gun on it, or perhaps you are turning an adjustor rather than a mounting bolt - pictures would be
more helpful.
Is it on the strut turret or by bracket do you mean supspension arms/subframe? I don't know anything about the camry but I know a few of the
japanese cars have series of adjustment bolts on the subframe for camber/castor/toe etc.
A bird in the hand....
|
|
Sprytny
|
posted on 18/4/10 at 06:05 PM |
|
|
"Is the entire assembly moving? If so, get a rattle gun on it, or perhaps you are turning an adjustor rather than a mounting bolt - pictures
would be more helpful. "
It possibly might be an adjuster. I will post pictures once I can. The whole assembly does move. What is a rattle gun, and where would I apply it?
There is a subframe, but I really don't want to remove this to remove the suspension as it is hard work to get off!!
Thanks again . . .
|
|
speedyxjs
|
posted on 18/4/10 at 06:14 PM |
|
|
My rear hubs did this. Rubber mallet on the end of the bolt normally gets them moving.
How long can i resist the temptation to drop a V8 in?
|
|
tomprescott
|
posted on 18/4/10 at 06:16 PM |
|
|
Rattle gun (slang) for an impact wrench - usually air powered but can also be electrical. Impact wrenches can loosen stiff nuts which is a possible
problem for you, the nut may be on so tight that when you try to undo it, instead of twisting the nut off its shaft, you twist the nut and shaft
together....
A bird in the hand....
|
|
Sprytny
|
posted on 19/4/10 at 09:58 PM |
|
|
picture
Hi
I have taken a picture of the strut. The adjuster bracket cannot be removed; as I mentioned it turns round and round without the nut coming out. I
tried the 'impacting' technique to no avail. Any ideas?
![](/galpreviews/a1134018-Photo-0044.jpg) ![Rescued attachment Photo-0044.jpg](/gallery/a1134018-Photo-0044.jpg) Rescued attachment Photo-0044.jpg
|
|
Sprytny
|
posted on 20/4/10 at 10:17 AM |
|
|
Strut removal
I have tried to follow the haynes manuals instructions to remove this component, but I am still struggling. Would I need to remove the bottom bracket
to remove this - the nuts here seem rusty and awkward!!
|
|
boggle
|
posted on 20/4/10 at 11:22 AM |
|
|
gas axe???
or just a bit of heat??
just because you are a character, doesnt mean you have character....
for all your bespoke parts, ali welding, waterjet, laser, folding, turning, milling, composite work, spraying, anodising and cad drawing....
u2u me for details
|
PLEASE NOTE: This user is a trader who has not signed up for the LocostBuilders registration scheme. If this post is advertising a commercial product or service, please report it by clicking here.
|