Hi I'm installing a 2006 R1 engine in my 7, which used to have a Rover K-series engine. The high-pressure fuel line to the injectors ends in one
of these:
[img]http://www.flickr.com/photos/charlieandhelen/5233604651/[/img]
and the fuel rail ends in one of these:
[img]http://www.flickr.com/photos/charlieandhelen/5234197576/[/img]
What's the best way to link it up?
[Edited on 5/12/10 by charlie_pank]
The first one is a barbed fitting with a clamp over the hose, I would gently remove this and use as a new fitting on the old line.
My zx10r is connected using approved flexible hose for petrol and clamp suitable for petro etc, very like a normal hose clamp.
Cool, it's done, and I'm onto the loom (oh dear!...)
When doing mine this was the best source for info on the R1 wiring mods.