MakeEverything
|
posted on 28/12/10 at 03:15 PM |
|
|
42mm copper elbows?
Anyone know where best to get them cheap? Im looking at Plumb Centre etc at the moment, but they dont seem that cheap tbh.
I want to use them as my coolant system elbows, which i will join with the straight silicone couplers that i'll cut from my 1m length.
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
|
r1_pete
|
posted on 28/12/10 at 03:18 PM |
|
|
5 for £25 BN YORKSHIRE YP12 42mm SOFTLEAD FREE SOLDER COPPER BEND on eBay (end time 05-Jan-11 17:53:40 GMT)
|
|
Mal
|
posted on 28/12/10 at 03:25 PM |
|
|
£5 for one here:
http://www.bes.co.uk/
|
|
MakeEverything
|
posted on 28/12/10 at 03:56 PM |
|
|
Thanks guys, ive seen all of the above, but wondered if there was any cheaper alternative to £5 per bend.
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
MakeEverything
|
posted on 28/12/10 at 03:58 PM |
|
|
Plain elbows will do, as i can put a bead in them for the hose connectors myself. Plain elbows might be cheaper than yorkshire fittings?
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
Strontium Dog
|
posted on 28/12/10 at 04:03 PM |
|
|
try here very reliable firm
http://www.bes.co.uk/
item no. 9182
|
|
MakeEverything
|
posted on 28/12/10 at 05:11 PM |
|
|
Well, i ordered 8 x 90 bends, 3 x 45 bends and a reducer for the expansion take off.
All Endfeed capillary fittings, not yorkshire.
Thanks guys for the help.
[Edited on 28-12-10 by MakeEverything]
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
BenB
|
posted on 28/12/10 at 06:52 PM |
|
|
Once you know how end-feed is much better than solder-ring (Yorkshire). So far on my house renovation the only joints I've had leak are where
solder-ring fittings were used (on the basis I'd run out of "proper" ones).... Now I routinely give the Yorkshire ones a lick of
solder at the ends once they're hot (which kind of defeats the point of using the solder-ring in the first place!). But hey. Since doing that no
leaks on Yorkshires either...
|
|
Horizenjob
|
posted on 31/12/10 at 07:36 AM |
|
|
They make elbows with a larger radius, which might be a good idea for coolant flow.
long turn elbows
Scroll the product selection to the right at that site. I figure they should be available on your side of the pond too.
|
|