Not sure how to descibe this. For my SVA in Dec 2005, i got a vinyl covered ali panel from Mac#1 to affix to my dash so there was no problems with the
under dash rad (which from memory conformed just to SVA reqts but depended on how it was tested if it defo passed or not).
I may have got it just after Jos. Does anyone have a picture of it? I cant find my picture and a fellow ne7er needs some inspiration.
Thanks in advance,
Darren.
I don't know if it would fit, but krismc might be interested - see here
Darren,
I used it for my SVA since i have the "old" style dash.
It was a piece of thin ali about 12" * 12" with a right angle bend in it that when under the dash. It was covered in some faux leather
plastic.
HTH
-- Ash
Here it is, from Jos's archive
http://www.locostbuilders.co.uk/photos.php?action=showphoto&photo=051208-05.JPG
Thanks guys. I posted this for Kris's benefit.
The one in the pic is different to the one i used but the same principle. i stuck mine on with industrial grade double sided tape. Mine didnt go as
high up and had a simple curve to lower edge (probs bent around some drain pipe).
Cheers guys ill have a look what i can scrounge to make one
Ill try that but all my guages are accross there so only go about 1-2 inches up dash.
the legendary Dwarf board, first used on my old orange car. I'm sure its still in the workshop somewhere, certain it survived the fire
Wasnt the dwarf board the one that went right down to the floor? I was thinking about the other one that just corrected the dash rad.