Board logo

Duratec inlet side alternator mounting pictures
ceebmoj - 8/6/15 at 11:59 PM

hi guys please can see some pictures and details of your Duratec inlet side alternator mounting?

[Edited on 8/6/15 by ceebmoj]

Kdempsie - 9/6/15 at 09:41 AM

Hi, mine is shown here https://jpsc.org.uk/forum/viewtopic.php?t=1209&start=30

It might not be very clear from those pictures though. I didn't do anything clever, just bought the kit from Raceline.

Keith.

mackei23b - 9/6/15 at 12:09 PM

Not mounted, but here are my home made brackets...

Description
Description

Cheers

Ian

ceebmoj - 9/6/15 at 06:55 PM

Which alternator is that and do you need to swap the puly?

big-vee-twin - 9/6/15 at 07:28 PM

Nippon Denso Alt found on Daihatsu Charade among others pulley from Burton Power.

New Alts can be had from Brise if you have deep pockets.

mackei23b - 10/6/15 at 09:52 AM

Burton Power for my pulley as well.

Cheers
Ian

ceebmoj - 12/6/15 at 12:09 AM

Last question I think. What belt size have you used and what is its origin?

peter030371 - 12/6/15 at 07:20 AM

quote:
Originally posted by ceebmoj
Last question I think. What belt size have you used and what is its origin?


I have yet to measure up what size belt I need but this site is book marked for the day I do Not used them yet but they seem to have a decent range http://www.camskill.co.uk/m28b0s0p0/Cambelts_Auxilliary_B elts_Drive_Belts_and_Fan_Belts

mackei23b - 15/6/15 at 08:36 AM

Hi There

A 6PK belt is what is required, any good motor factor will be able to order one in. I use a local motor factor and picked up a belt the same afternoon.

Depending on the bracket used there will be some variation in length. I used some tape and measured the length round the pulleys, if you are plus/minus 15mm the tensioner will still be able to cope with this from its midpoint.

Cheers

Ian