Mac#1 suspension bushes

Not logged in [Login - Register]

LocostBuilders » Forum » Mac #1 » Mac#1 suspension bushes

MIG Welders & ARC Welders at MachineMart.co.uk

Printable Version | Subscribe | Add to Favourites

matty h

Senior Builder

Posts 998
Registered 28/11/09
Location North Lincolnshire
Member Is Offline

Photo Archive Go!

Building: GTM Libra 1.8vvc + Westfield SEIW 1.8vvc

posted on 4/8/18 at 06:14 PM

Mac#1 suspension bushes

Looking for some new bushes for the front of a mac#1 are these ones any good size wise to save me stripping them out before ordering.

https://www.ebay.co.uk/itm/Haynes-Roadster-Locost-Wishbone-Bush-set-of-4/252431577208?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649 r />
Matty

[Edited on 4/8/18 by matty h]

40inches

Contributor

Posts 5009
Registered 16/2/05
Location Eckington, Derbyshire
Member Is Offline

Photo Archive Go!

Building: MK Indy, Jaguar AJ30 V6 engine

posted on 4/8/18 at 06:39 PM

The Mac#1 was basically the same as MK. So I would think MK bushes would fit?

OliilO

Contributor

Posts 313
Registered 6/2/13
Location Reading
Member Is Offline

Photo Archive Go!

Building: Mac#1 Worx

posted on 21/5/19 at 07:51 PM

Dragging up an old topic, but has anyone had any success in finding some bushes for Mac#1 wishbones?

I ordered some from kitcardirect assuming they are the same but they are too small for the Mac#1 wishbone. Measuring my existing ones gives dimensions of 32mm OD and 19.5mm ID.

LocostBuilders » Forum » Mac #1 » Mac#1 suspension bushes

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.