just fitted a double bubble aeroscreen from Aerodynamix.. lovely bit of grp but fit not quite as good.. never the less she is on..

does anyone else have a small gap in the corners due to the step in the scuttle when fitting aeroscreens?

I did, but I removed the step and glassed it over.

Description

even my carbonmods did have small gaps on one of my cars. a bit of foam or edge trim along bottom edge is better, as it also stops the wind from going straight under it (which it will do)

Yes i do i put sponge strip under the aeroscreen

Thinking of getting one of these myself. Any chance of pics?

Thanks

Andy

Ive just fitted one also and only have a small gap under the drivers bubble, but I was almost stretching it over so the sides are nice and tight.
Will try and get some pics up tomorrow great work from aerodynamix

Yep mine had a gap on one side (the scuttle is not even close to being symmetrical). I ground down the step to get it to sit flush.

thanks for the info Guys.. I think i'll make some little infill panels and colour code them.. Don't fancy hacking the car about to get a screen to fit..