Hi People.
I'm installing a CBR1000 engine into my car and am getting to the plumbing.
Anyone got photos of their installation so that I can figure out the plumbing of the radiator / water etc?
Vince
Which engine do you have
Early - Outlets at the rear of the heads, just below each of the outer carbs
Later - Outlets on each side of the head?
Thanks for the reply Shandylegs.
I'll take a photo and post it tonight when I'm home.
I've an FP (92-93) - various pics in archive - swapped from an FJ (88) - so might have pics of both
main difference was water in&out changed from left side to right side (from standing in front of car)
[Edited on 5/5/10 by skidude88]
Just looked - not as many pics as I thought of the new lay out - I'll upload a few more
[Edited on 5/5/10 by skidude88]
[Edited on 5/5/10 by skidude88]
Vince - I've uploaded a couple of old pictures that may be of use.
Thanks....
Thanks guys.
I never got a chance to take pics of mine tonight, small family crisis. Will try over the weekend. Thanks for posting your messages guys. Hope to
get there in the end.