Hello All,

Due to immanently moving house, the garage has gone through a major clear out, resulting in a few bits that i would like to offer for sale. All this is located very close to Junction 13 of the M1, although i am willing to post anything if the buyer pays the cost.



Never used rear upright off a fury - modified to prevent the cracking problem - £10



Westfield Fibreglass rear diffuser for FW bodywork and ST1 and ST3 - New, never used - £65



Ali Catch tank - never been used - £15 - Sold to Chris



This was a weather cover to fit a Fury with a full roll cage - splits in half and fits tightly round the cage - free to anyone who wants it - SOLD / GIVEN AWAY



0.750 and 0.625 Wilwood Master Cylinder's - Non Integral - used - £20 for both with bar - Sold



4 inch, 4 jaw chuck for lathe - never used - £25 - SOLD to Ian



3 inch, 3 jaw chuck for lathe - never used - £20 - SOLD to Ian



Electric starter motor - no clue whats its off but was going to use it for an electric reverse - £10



Two part prop shaft for a fury - Freelander fittings one end, Honda CBR the other. £35



Silencer - only used once or twice as it was a little on the loud side ! - Stainless - £40


Any questions please feel free to ask

Cheers
Tris

[Edited on 10/6/14 by Tris]

[Edited on 11/6/14 by Tris]

[Edited on 11/6/14 by Tris]

Can I have the weather gear please!

Yes sure - U2U me regards if you want to post or collect.

Cheers
Tris

Tris
How big is the catch tank?
Cheers
Iain

Hello Iain,

Taken from the receipt email -

2 Litre rectangular bulkhead mounted oil catch tank.
Twin 1/2” inlets,1/2” breather outlet, drain plug and sight tube, comes with clear pipe. 200 x 155 x 70mm

Cheers
Tris

[Edited on 10/6/14 by Tris]

master cylinders and bias bar please..

let me know how you want payment.

thanks Gavin

Hi Tris,

Could I have first dibs on the 2 lathe chucks please, pending more details as I need to make sure they will fit my lathe?

Have you got the spec for the fitment, thread size etc please? If you have the manual/spec You can email it to me and I'll check.

Cheers
Ian

Ian and Gavin - you have U2U's

will have the catch tank if its still available.
cheers
chris
u2u sent

Will you post the diffuser?
Can you give me the dimensions also?
Thanks.

Tris

I've replied to u2u thanks to say I'll have the chucks. Have to go to work but back on the forum around 6pm.

Cheers
Ian

Loggyboy - yes to posting - its 230mm wide - 880mm long

quote:

---

Originally posted by Tris
Loggyboy - yes to posting - its 230mm wide - 880mm long

---

Hi,

can I buy the diffuser please. I would need it mailed but happy to cover all costs.

Kind Regards
Phil.

Hello Phil - U2U sent

Is the starter motor a reduction geared down one (slower speed, higher torque to suit reverse solution)?

Thanks,

Craig.

Many thanks Biz for the thought but that's a later upright than I need :-( got all excited too