Hi all,

Trying to figure out what type of fixing goes in the holes in my bonnet and boot lid. The top part was removed to be replaced, but then lost.

This is the hole in the bonnet:



This is the hole that it fits onto:



This is whats underneath the receiving hole:




The big hole is 15mm across, and there is roughly 27mm between the two small holes which I assume are for pop rivets.


Anyone fill in the blanks for me?

They're for Dzus Fasteners....







[Edited on 31/5/14 by JAG]

I think they are dzus fastener's

Must type faster...

DZUS

quote:

---

Originally posted by adithorp
Must type faster...

---

excellent thanks guys.

How to I measure them to get the right size?

As other have said they Dzus. Had a really good guide to measuring and fitting but can't seem to find it. However this may help http://pitstopusa.com/p-4099-dzus-fastener-measurement-guidelines.html
My take a while to get into the decimal inches instead of millimetres, but all the guides I've seen are like this. Hard to tell from pic but the spring may be fitted the wrong way round.

Rally Design & Demon Tweeks have diagrams for measurement

Is that another beautiful yellow Gemini bonnet.

I have one as well. 2 nad half years since SVA.

quote:

---

Originally posted by Gemini
Is that another beautiful yellow Gemini bonnet.

I have one as well. 2 nad half years since SVA.

---

Hi Yes wouldbe interested.

Always good to see other ideas/viewpoints

Dave