rich201283
|
posted on 17/4/12 at 08:07 AM |
|
|
Weller wheel wobble after powder coating?
I have powder coated my weller wheels but when i have fitted them there seems to be wheel wobble.
I think this maybe due to the thickness of the powder coating where the wheel meets the hub, Should i remove the coating from the back of the wheel
where it meets the hub?
|
|
|
Pdlewis
|
posted on 17/4/12 at 08:17 AM |
|
|
have you had them balanced again since the powder coat? as their is a fair chance the coat will have taken the wheel off balance
Build Photo Album
Updated 05/02/2009
|
|
maccmike
|
posted on 17/4/12 at 09:44 AM |
|
|
need balancing
|
|
loggyboy
|
posted on 17/4/12 at 09:52 AM |
|
|
I would defo remove the paint from the mounting face first.
I would assume they were balanced after refiting tyres, so unless they have thrown a weight off.
The only other thing would have been deformation when being baked, but thats highly unlikely.
|
|
bi22le
|
posted on 17/4/12 at 04:37 PM |
|
|
It sounds like the 'wobble' when tight but not moving otherwise you wold of said they were unbalanced or vibrating. If so I had exactly
the same problem. . .
I noticed on one of my wheel sets that the silver coating did not allow the hub centre to go through the middle hole of the wheel. I think it just
gives the studs extra support and helps it centre the wheel. You know the big hole surrounded by the whell nut holes. I just shaved the coating off
back to ali and it was fine.
The bit I am talking about is the black part of the wheel in my avatar.
HTH
Biz
Track days ARE the best thing since sliced bread, until I get a supercharger that is!
Please read my ring story:
http://www.locostbuilders.co.uk/forum/13/viewthread.php?tid=139152&page=1
Me doing a sub 56sec lap around Brands Indy. I need a geo set up! http://www.youtube.com/watch?v=EHksfvIGB3I
|
|
britishtrident
|
posted on 17/4/12 at 05:36 PM |
|
|
The wheels need proper balancing.
[I] “ What use our work, Bennet, if we cannot care for those we love? .”
― From BBC TV/Amazon's Ripper Street.
[/I]
|
|
Slimy38
|
posted on 17/4/12 at 05:49 PM |
|
|
You need to skim the back of the wheel where it meets the hub, powder coat simply isn't flat enough to have as a mating surface.
I'd also recommend removing the powdercoat where the head of the wheel bolts/nuts sit, I've heard some horror stories about a supposedly
torqued wheel bolt not staying in place because of the powdercoat.
You also need them balancing, you can't powder coat with a tyre on (the tyre would cook) and unless they put the tyre back on perfectly as it
was it's going to be off balance.
|
|