I'm intending to fabricate an inlet manifold for my pinto to take R1 carbs. I need to provide a CAD drawing of this so that it can be cut on a flow jet. I had intended to do this at the Christmas break, but as always other things seem to get in the way of making progress other than a a snails pace. Before I set about trying to measure and draw one, does anyone have one already which they would be prepared to share? Any help much appreciated.

is a CVH a pinto? i forget...

if it is, here you go!
jason at short track is on here too

Inlet manifold gasket then make one with a drill and file it will keep you fit and warm

No, a pinto is a single overhead cam engine, unfortunely different from a CVH. I did look on the bay, as I knew Jason sold plates there, but he doesn't advertise one for a pinto, and when I sent him a sellers question before asking about one, I didn't get a reply. So I assume he doesn't do them.

I think Flak Monkey has one, maybe worth an ask.

Cheers

Rich

[Edited on 1/2/09 by RichardK]

Hello All

Best way to contact us is by Email EBay are getting hot on sales out side of listings.

Have sent u2u about pinto inlet flange.

Shorttrack Motor Sport Email

Jason

Dxf attached, but please check it against a gasket as it might need tweaking a bit. I cant remember if I finished it off or not...

Cheers,
David