Aft'noon all

Just looking for an approximate jet size for a set of GSXR600 (Mikuni) carbs on a standard 2L Pinto (205 block). The standard size is 1.25mm and i am guessing these may be slightly too small?? Anyone??

Cheers
Paul

[Edited on 25/2/09 by Paul TigerB6]

I'm running 1.6mm in ZX6R carbs on a 2.0 Zetec.

Seem to work OK, but haven't tested AFR yet.

Stu

I am running ZX6R carbs on a 1700 crossflow 244 cam, flowed head and Megajolt, moved up progressively to 170 (1.7mm) jets, seems about right.

Thanks gents. I'll drill the standard jets out to 1.5mm as a starting point then and see how it runs at that. Easy to then progressively increase the jet size till it runs well enough to get through SVA and then to the rolling road