Connected JAW Vout2 to MS but not getting any reading on the AFR gauge.

JAW set to emulate LC1
Configurator set to LC1 in settings.ini
EGO set to Single Wideband

Voltage from JAW changes when tested with butane on the lambda sensor.

Gauge works OK using the Stimulator.


Am I missing something obvious or just being stupid ?



Clive

Think Tim Windmill nearly got his working, maybe worth a u2u?

Cheers

Rich

Snuggs have you got a wire connecting either your Vout1 or Vout2 on your JAW pcb board to your megasquirt O2 signal wire on your db9 connector

Hi Tim,

Vout2 is connected to pin 23 on the DB37 connector.

I have been trawling the net for more info on this and I believe I need to change some settings in the ENRICHMENT menu but I cant figure out where this menu is

Voltage out of JAW checks out OK using a multimeter.

Clive