The pins used in mini timer housings ie the plugs used on standard bosch injectors. I am also looking for the little tool to remove the old pins.

any ideas greatfully received

I have a few new plugs in my bit-box - how many do you need ?
Mine come as `left-overs' at work

Hi Claire, erm dont know I havnt added them up yet

I guess
8 for injectors
3 for coil
3 for map sensor
4 for temp

so would be better if I bought a bag full

Thanks any way.

ps I understand there is a tool to remove them from the plug any pointers or ideas on this ?

cheers

[Edited on 28/2/10 by big_wasa]

think you can get them and the removal tool from vehicle wiring products, HTH
Stott

I have had sucsess using 2 bits of mig welding wire to get the pins out of the housings

Thanks for that I know I seen them someware and they have the pins. cheers.

Auto Electric Supplies and Vehicle Wiring Products as suggested

Fiddly little buggers

As for removing the old pins a small jewellers screwdriver does the trick for me. There is a notch either side of the pins, shove a screwdriver in there until you feel it click, repeat on both side of the pin and it should come out.