I'm yank builder just purchased an 05 duratec without computer. It has coilpacks with small gauge wires (not high capacity wires) and no distributor coils. Want to use MSnS-E for full ignition and fuel management.

I cannot find a schematic of the ignition to determine how the spark is controlled. I am new to the whole EFI thing but from what I have gathered so far the MSnS-E is not yet fully developed for full individual coil pack control. Anyone fill me in?? A schematic would really help if anyone has one to share.

hi and welcome....
have a look here mate


http://www.extraefi.co.uk/


tony

Easiest thing to do is ditch the COP and find a single coil pack off an earlier duratec.

MSnE wont do COP without additional coil drivers. It may not even do wasted spark depending on your set up and version.