Ok its not quite a fuel injection post but....
I need to make some insulators up for the temporary carb setup I'm working on, does anyone know a supplier of either the plastic used by some
manufacturers, or the thick paper/fibre stuff used between carbs and the manifold?
I need something in the order of 5mm thick.
Anyone know what the materials are called, and / or a supplier?
[Edited on 13/8/10 by r1_pete]
I think it's called Phenolic, a glass/resin compressed gasket that stops heat to the manifold from the block
Found it
Here
http://www.directplasticsonline.co.uk/PTFESheet/0.5mm/
You'll want thicker than 1/2 a mill to be effective
5 mm min to 10 mm
You'll want thicker than 1/2 a mill to be effective
5 mm min to 10 mm
It was more the link to the source, rather than the actual product (I just grabbed it from my bookmarks as I've used that on other projects).