I'm just finishing the throttle bodies (GSXR750 k8) for my jag engine, I need to blank the secondary injector drillings, I can turn tight fitting
plugs up, but, what have others sealed such plugs with?
All suggestions & experiences appreciated.
GSXR bodies
[Edited on 22/6/11 by r1_pete]
I turned up some blank plugs then put the body's in a low oven for few mins and bungs in the bottom of the freezer for a few hours and just
pushed the in quickly using a pair mole grips then ground down the surplus all this is ok if you have acess to a lathe
[Edited on 22/6/11 by will121]
Looks neat, thats tomorrow evening taken care of, Thanks.